Introduction
Access Logic gives the possibility to create a configuration of Access Control Policy. Thanks to it you can define what conditions must be met to grant access to a specific zone in your club. In order to correctly perform the setup, it is necessary to go through the three steps of configuration - Access Logic Definition, Access Logic Device configuration, and Access Server Station configuration.
- This article gives an overview of the Access Logic feature.
- This article will be helpful to PG Champion, Club Owner, and IT Department.
Feature description
To enter the Access Logic module go to PGM -> Settings -> Access Logic.
The following screen will appear.
There are several tabs available in this module, each allowing you to perform different actions. These three steps need to be set up for a proper access control policy in your club.
Access logic definitions – this is the first step where you need to define how access devices should behave after scanning the card during entrance to the club or specific zones. It also determines what should be checked during the scan and what should happen after the successful and unsuccessful scan. Learn more about this configuration.
Devices – this is the second step, you can add the device and assign it to the Access Logic configured beforehand. Here you also need to define if the device reader should be configured as an Entrance Gate or Exit Gate according to its position as well as assign it to a specific club and zone. Learn more about this configuration.
Access Server Station – this is the last step of the configuration where you need to add the Access Server Station to the appropriate club where it should work. Access Logic Server is a collection of devices, their configurations, along with access logic assigned to a specific club. Learn more about this configuration.